It appears that you upgraded from LE to the full Pro, so have already taken advantage of the discount that LE offers you to upgrade. Please see comparison for a summary of the main differences between LE and the full Pro. The full Pro also gives access to all features of the software including full-screen video mixing, the ability to custom map buttons yourself, etc. The full Pro is required for access to all custom downloads (Such as skins, effects, customised user-made mappers, etc.) and to be able to continue using them outside of the 20 day Pro trial. It's limited software and will allow you to use your controller with limited functionality. You may click on any of the Mode buttons to change the Mode.ĭuring playback, the Calibration Scope should display a stable Timecode signal, as pictured below for Timecode vinyl and Timecode CD.įor more information on Relative and Absolute Mode, please refer to chapter 'Tracking Modes' in the TRAKTOR 3 user manual.VirtualDJ LE is limited software bundled with selected controllers and cannot be purchased separately. During playback, either the Relative or Absolute Mode button will light up. Now you can close the Preferences and start the playback on your Timecode Deck by dropping the needle on your running Timecode record or pressing play on your CD Player to run the Timecode CD. In the section Platter / Scope, choose Scope for the Decks you want to control with Timecode.Go to the Decks Layout section in the TRAKTOR Preferences.The Scope Panels are a graphical representation of the Timecode signal and allow you to trigger its calibration. In order to monitor the incoming Timecode signal, activate the Scope Panels for both decks. Connect your headphones to the dedicated connector on your sound card and assign the corresponding channel to Output Monitor. In order to configure this setup, connect one output channel of your sound card to the line input of your speaker system and assign this channel to Output Master. Go to the Output Routing in the TRAKTOR Preferences.Note: This setup requires a sound card which offers a headphone connector. If your setup does not include an external mixer, you can also use the Internal Mixing Mode. The signal from Deck A will go to the Output Channel A ( SL4 Out 0-1) on the audio interface, Deck B will go to Output Channel B ( SL4 Out 2-3) and so on. The outputs will automatically be set in the correct order, which looks like this: Go to Output Routing in the TRAKTOR Preferences.If you are using an external mixer, connect the outputs of your audio interface to the LINE inputs (not PHONO!) of your external mixer. Output Configuration External Mixing Mode Please refer to the documentation of your specific audio device in order to find the procedure explained. Note: Ensure to choose the right input mode depending on your audio device whether you use turntables or CDs. Make sure your audio interface is selected in the Audio Device menu.Īs next step, TRAKTOR's Input Routing needs to be configured: the inputs which your external hardware has been connected to must be assigned to Decks A AND B - this is how it looks:ĭeck A will be controlled by the Timecode signal coming in on Channel A left/right ( SL 4 In 0-1), Deck B by the Timecode signal coming in on Channel B left/right ( SL 4 In 2-3). When the Setup Wizard is finished, open the TRAKTOR Preferences and go to Audio Setup.In the DECK LAYOUT SELECTION, choose 2 Track Decks (Scratch). Run the Setup Wizard by clicking on the Setup Wizard button in the lower left corner of the TRAKTOR Preferences.Connect your turntables or CD players to the IN connectors of the audio interface.Make sure that your audio interface is connected to the computer and receives enough power (use a power supply if necessary).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |